7 ‘8’10.1′ 12.1 ‘13.3’ 15.6 ‘capacitive Touch Screen G+g Structure Usb Plug And Play 10 Point Touch – Tablet Lcds & Panels

precautions for use

When using the touch screen, please note the following:

1 as the capacitive touch screen is made of glass, do not strike forcefully or fall from a height.

2 do not put the capacitive touch screen from the FPC position.

3 do not overlap or press with heavy objects during storage.

4 do not directly contact the parts on the touch screen FPC with conductive materials such as metal, to avoid short circuit and other electrical properties
A good.

5 do not repeatedly bend or forcefully pull the FPC during installation to avoid folding injury; Avoid dead folds of 90 and 180 degrees (which can cause FPC wires)
Road fracture, resulting in poor product function).

6 do not touch the ink behind the capacitive touch screen with hard objects during installation to avoid scratches.

7 do not touch the visible area during installation. If touching causes dirt, please use the cleaning method specified by wentai touch to remove the dirt.

8 when operating capacitive touch screen, please use finger or conductive pen to touch.

9 pay attention to high voltage and ESD protection.

10 it is suggested that the customer tear off the protective film of the finished product before use, carry out necessary cleaning process and appearance, and then carry out subsequent processing and assembly work
The product protective film that has been torn off is pasted back to the product, because the protective film that has been torn off has been contacted by the operator inside the protective film, causing pollution, and then the product that has been torn off
Protective film affixed back to the product will certainly cause contamination transfer pollution

11 customers or users are strongly advised to completely tear off the protective film before using the product for appearance inspection or lamination, and then use the dustfree room for special purpose
The dust-free dry cloth plus an appropriate amount of cleaning solvent, wear clean gloves, and then use good cleaning techniques for cleaning, after effective product surface cleaning, however
After the appearance inspection, the appearance inspection must ensure that the product can not have.

12 it is strongly recommended that customers or users should completely tear off the protective film before using the product for appearance inspection or lamination, and then use the dustfree room for special purpose
Then wear clean gloves to clean the dry dust-free cloth plus an appropriate amount of cleaning solvent (such as IPA or Ethanol), and perform cleaning by good cleaning methods after effective production
After the surface is cleaned, an appearance inspection shall be conducted. After the appearance inspection, it is necessary to ensure that there is no additional dirt or dust or fingerprint on the product
Then it can be fitted and assembled.

Product structure diagram

7 inch 165mmX104mm

7 inch 164.9mmx100mm

8 inch 183mmX141mm

10.1 inch 227.43mmX149mm

10.1 inch 235mmX143.1mm

10.4 inch 225.12mmX173.44mm

12.1 inch 260.5mmx204mm

12.1 inch 276.8mmx182.4mm

13.3inch 305mmX177.8mm

15.6inch 360.5mmX207.42mm